Symptoms: No LED indication on the accelerator after power ON (magnet attached), motocycle is not responding.
Cause: Faulty controller setup
Solution: Perform a controller factory reset:- Push and hold the Torque & Speed (Mode) control button.
- Turn the motorcycle kill switch ON (magnet attached).
- All 3 LEDs on the accelerator will blink for the 1st time, for the 2nd time, for the 3rd time and after 5 seconds they will start flashing rapidly.
- Twist the accelerator to its maximum and hold it in this position.
- Release the Torque & Speed control button - the LEDs will stop flashing.
- Wait, until the LEDs will light up without flashing, then release the accelerator.
- Turn the motorcycle kill switch OFF (magnet not attached).
If this solution does not help to solve Your issue, please see other knowledbase articles.