Voltmeter/battery capacity indicator setting

If You have ordered the voltmeter separately, You may need to adjust its parameters for it to function correctly after installation on the motorcycle.

Table of contents:

Basic settings
Special settings

1. Basic settings

Follow these steps to set the battery type and number of cells connected in series

Make sure, that the magnetic kill switch is in OFF position (magnet NOT attached).
Press and hold the Setting button (left) and turn the motorcycle ON (magnet attached), then release the button. The letter P, F or L will be blinking and the device is waiting for You to set the battery type.
By pressing the Setting button (left) several times set the battery type:
P for Lead-Acid battery (12 V per cell)
F for Li-Fe-PO4 battery (3.2 V per cell)
L for Li-Ion battery (3.7 V per cell), which is used in all 48V KUBERG motorcycles
Confirm Your selection by pressing the Function button (right). The number parameter will be blinking and the device is waiting for You to set the number of cells connected in series.
Press the Function button (right) several times to set the ammount of cells in series to 13. Because 13 x 3.7 V = 48 V (nominal voltage) and 13 x 4.2 V = 54+ V (fully charged).
Turn the motorcycle OFF to save the basic configuration.
Turn the motorcycle ON and now You can toggle between functions using the Function button (right).

2. Special settings

Follow these steps to set the special settings:

Make sure, that the magnetic kill switch is in OFF position (magnet NOT attached).
Press and hold the Setting button (left) and turn the motorcycle ON (magnet attached), then release the button. The letter P, F or L will be blinking and the device is waiting for You to set the battery type.
Press the Function button (right) once to switch to cell number setting.
Press and hold the Function button (right) for 2 seconds to switch to special settings, until You'll see the "S - 1" value on the LCD, then release the button. Now You can change the following functions. Each function can be set ON (black bar graph visible) or OFF (black bar graph NOT visible)

S1 - automatic LCD data (bat. % and bat. V) toggle every 2 seconds when the function is ON // manual toggle (bat. %, bat. V and sleep state) using the Function button (right) when the function is OFF
S2 - automatic sleep after 10 seconds when the function is ON // permanently showing the data when the function is OFF
S3 - backlight ON (OFF in sleep state) when the function is ON // backlight OFF when the function is OFF
S4 - not used
S5 - not used
Press the Setting button (left) to switch between function S1 - S5 and press the Function button (right) to either set the value to ON or OFF.
Turn the motorcycle OFF to save the special settings.

If Your motorcycle is under warranty, please register it on our website, if You have not already done so:
https://www.kuberg.com/en/bike-registration

If the problem persists, please contact Your dealer or KUBERG customer service (support@kuberg.com). For the fastest possible resolution please send:

VIN of Your motorcycle (it is stamped on the right side of the steering column).
Detailed information on actions taken so far, a few photos and preferably a video.

Rating:

No rating has been done yet.

Only registered users can rate

Voltmeter/battery capacity indicator setting

Quick Links

Contact Us