Start/Trial/Cross: Wi-Fi dongle Volt app availability

The VOLT app is no longer supported and available from the Apple Store due to Apple policy and currently works only on older iOS (2018).

The older VOLT app is still available for Android, You can download it here: KUBERG VOLT app from Dropbox

We’re preparing completely new motorcycle managing system for modern iOS and Android. Meanwhile You can still control torque and top speed of Your motorcycle by following procedures.

WARNING!
As the responsible adult You must ensure, that the KUBERG motorcycle and its rider are prepared for every ride. Failure to do so and the torqie and the top speed will be set too high, it may result in an injury or death and/or damage to your motorcycle. The motorcycle must be set to the abilities of the rider and you must always supervise, where and how the motorcycle is ridden. Children can lose concentration quickly and be distracted easily.

Table of contents:

Torque setup
Top speed setup

1. Torque setup

Follow these steps to set the engine torque:

Ensure, that the magnetic kill switch is in OFF position (magnet NOT attached).
Place the motorcycle on a solid and level surface of a mounting stand, so that the rear wheel is off the ground.
Press and hold the Torque & Speed control button.
While holding the Torque & Speed control button, turn the magnetic kill switch in ON position by attaching the magnet on the string and watch the LEDs on the accelerator. The LEDs will blink for the 1st time, pause, for the 2nd time, pause and for the 3rd time.
• 1st blink - Beginner mode (low torque and power consumption)
• 2nd blink - Sport mode (medium torque)
• 3rd blink - Race mode (unlimited torque)
Release the button, just after the number of flashes corresponds with your desired torque mode. The torque mode is now set and will stay stored, even after you turn the motorcycle OFF and ON again.

For example if you want to set the medium torque mode, push and hold the button, start the motorcycle, while still holding the button, wait for 2nd flash and then release the button.

WARNING!
If you set a different torque mode, the top speed setting will be reseted to default (unlimited) value.

2. Top speed setup

Follow these steps to limit the top speed:

Ensure, that the magnetic kill switch is in OFF position (magnet NOT attached).
Place the motorcycle on a solid and level surface of a mounting stand, so that the rear wheel is off the ground.
Turn the motorcycle kill switch ON (magnet attached) and wait 5 seconds.
Press and hold the Torque & Speed control button.
When all LEDs start to blink rapidly, spin the rear wheel to your desired maximun and keep the twist to the accelerator, then release the button while still keeping the twist.
When the LEDs turn off and the motor stops running, release the twist. The top speed is now set and will stay stored, even after you turn the motorcycle OFF and ON again.

For example if you want to set a top speed to the half of the motorcycle’s maximum 17 mph (27 km/h), start the motorcycle, push and hold the button, apply a half twist, release button, while still keeping the half twist and then release the accelerator.

WARNING!
If you set a different torque mode, the top speed setting will be reseted to default (unlimited) value.

If Your motorcycle is under warranty, please register it on our website, if You have not already done so:
https://www.kuberg.com/en/bike-registration

If the problem persists, please contact Your dealer or KUBERG customer service (support@kuberg.com). For the fastest possible resolution please send:

VIN of Your motorcycle (it is stamped on the right side of the steering column).
Detailed information on actions taken so far, a few photos and preferably a video.

Rating:

No rating has been done yet.

Only registered users can rate

Start/Trial/Cross: Wi-Fi dongle Volt app availability

Quick Links

Contact Us